Ra3 pricing1/23/2024 Then you can put the switches just inside the pantry or closet, directly in the same location as they would ordinarily be installed, just facing into the adjacent pantry/closet/whatever. There is one type of location where I think this setup could work without much difficulty: a walk-in pantry that shares a wall with the kitchen entrance, or a walk-in closet that shares a wall with the master bedroom entrance, or similar. Anyway, just my personal opinion, I know others could likely disagree. It’s an extremely heavy-handed solution for a home that will in all likelihood survive longer than RA3 as a technology choice and force that hard-wired/routing decision on every single owner for the next 50 (or more) years at least.īased on this, I personally prefer to stick with a paradigm where the controller/switch is always at the load location. If “Technology X” arrives in 10 years that makes all those hardwiring changes obsolete, or requires a different protocol, or whatever, well, now you’re stuck with a ton of electrical wires routed to a closet somewhere and anytime you want to change or work on anything, or troubleshoot, or swap out to a different technology or solution, you’re screwed and forced to work with that setup. It’s a nearly permanent solution (barring ripping out drywall everywhere) that forces you and all subsequent homeowners to use the Lutron system indefinitely. I did a lot of research, talking with other Lutron customers, and reading on Reddit’s r/Lutron community, and, while I now understand what you’re saying and could envision how it would look super clean, I personally think this isn’t such a great idea. Thanks so much for the clarification and example! Switches can be installed out of site instead of at the entrance to the room and then where they would normally go a single keypad can be installed. ![]() Would Lutron Radio RA2 or RA3 benefit me in any way? What would I be missing with ‘just’ Caseta? I’ll probably run one physical server with a hypervisor (VirtualBox, ProxMox, whatever), with Home Assistant in a VM. What benefits, if any, would Radio RA2 or RA3 give me over Cat6a-connected devices and Caseta for switches/dimmers?įWIW, I’m a software engineer/architect by trade (so programming is no inconvenience), and I’ll be running a full Ubiquiti Unifi rack/switches/etc, in a central closet. condo being built and I’m working with the low-voltage installers to run multiple Cat 6a cables to every room for PoE sensors, cameras, multimedia devices and TVs, etc. ![]() Since Home Assistant and Lutron Caseta seem to be well integrated, and you can create your own HA tablet and mobile dashboards for full home control, and apparently even get around the Caseta 75 device limitation by bridging two Lutron hubs with HA - why would someone want to pay the extra cost to go with Lutron’s Radio RA2 or Radio RA3 systems instead?
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |